L-319-1
Adhesive Primer / Corrosion Inhibiting
Click For
Page 1
Application
  • Prior to priming, aluminum detail parts should be cleaned and etched to a water break free condition. The details should be rinsed and dried.
  • Apply L-319-1 immediately after drying is completed and within a time limit which prevents the reformation of aluminum oxides on the detail surface.
    1. Allow L-319-1 to reach room temperature before opening the container.
    2. Mix thoroughly and spray details with a uniform cross coat to a dry film thickness of 0.0001” to 0.0003” (0.0025-0.0076 mm) thick.
    3. Air dry detail parts for 30 minutes minimum, followed by an oven bake at 250°F (121°C) for 60 minutes.
    4. The details should be stored in a clean, dry environment prior to lay up and bonding.
Average Mechanical Properties
Overlap Tensile Shear Strength
Coupons primed with L-319-1 and bonded with L-314 Film Adhesive, cured 1 hour at 250°F (121°C).
ASTM D1002
  • -67°F (-55°C) 6460 PSI (44.4 MPa)
  • RT 5480 PSI (37.7 MPa)
  • 180°F (82°C) 4340 PSI (29.8 MPa)
  • 250°F (176°C) 2450 PSI (16.9 MPa)
  
 
Click for Page 1

NOTICE:Product data and parameters cited in this publication have been obtained in J.D. Lincoln, Inc. laboratories using the materials under carefully controlled conditions. The information, therefore, is believed to be accurate and correctly stated. Data of this type may be considered to be indicative of representative properties obtainable. J.D. Lincoln, Inc. cannot accept responsibility for the misapplication of these products, nor for their use under uncontrolled conditions. Numerical values resulting from the application of this material are dependant on processing details. It is recommended that the user develop his or her own application techniques and generate data consistent with his or her specific application and process.

 
       
Website Copyright 1996-2008 by J.D. Lincoln Inc.
A Member of the Umeco Plc Group.